Linux内核--从上向下分析驱动程序层

　　在<Linux内核--Linux内核：从底层向上分析驱动程序层+链路层>中对网络设备结构，网络设备初始化等函数有了初步认识，并列出了设备的发送和接收函数。

　　设备接口层会调用函数设备驱动层ei_start_xmit()函数发送数据，这里没有详细分析。

static int ei_start_xmit(struct sk_buff *skb， struct device *dev)
{
    int e8390_base = dev->base_addr;
    struct ei_device *ei_local = (struct ei_device *) dev->priv;//取出网卡设备的私有数据，和具体的网卡型号有关，在ethdev_init()函数中已经分配空间
    int length， send_length;
    unsigned long flags;
  
/*
 *  We normally shouldn't be called if dev->tbusy is set， but the
 *  existing code does anyway. If it has been too long since the
 *  last Tx， we assume the board has died and kick it.
 */
 
    if (dev->tbusy) { /* Do timeouts， just like the 8003 driver. */
  ........................................
  ........................................
    }
  
    /* Sending a NULL skb means some higher layer thinks we've missed an
       tx-done interrupt. Caution: dev_tint() handles the cli()/sti()
       itself. */
    if (skb == NULL) {//该条件似乎不会发生，这用于处理内核中的BUG
  dev_tint(dev);//发送设备中的所有缓存的数据包
  return 0;
    }
  
    length = skb->len;
    if (skb->len <= 0)
  return 0;

    save_flags(flags);
    cli();

    /* Block a timer-based transmit from overlapping. */
    if ((set_bit(0， (void*)&dev->tbusy) != 0) || ei_local->irqlock) {
 printk("%s: Tx access conflict. irq=%d lock=%d tx1=%d tx2=%d last=%d "，
  dev->name， dev->interrupt， ei_local->irqlock， ei_local->tx1，
  ei_local->tx2， ei_local->lasttx);
 restore_flags(flags);
 return 1;
    }

    /* Mask interrupts from the ethercard. */
    outb(0x00， e8390_base + EN0_IMR);
    ei_local->irqlock = 1;
    restore_flags(flags);

    send_length = ETH_ZLEN < length ? length : ETH_ZLEN;

    if (ei_local->pingpong) {
  int output_page;
  if (ei_local->tx1 == 0) {
   output_page = ei_local->tx_start_page;
   ei_local->tx1 = send_length;
   if (ei_debug  &&  ei_local->tx2 > 0)
    printk("%s: idle transmitter tx2=%d， lasttx=%d， txing=%d. "，
        dev->name， ei_local->tx2， ei_local->lasttx，
        ei_local->txing);
  } else if (ei_local->tx2 == 0) {
   output_page = ei_local->tx_start_page + 6;
   ei_local->tx2 = send_length;
   if (ei_debug  &&  ei_local->tx1 > 0)
    printk("%s: idle transmitter， tx1=%d， lasttx=%d， txing=%d. "，
        dev->name， ei_local->tx1， ei_local->lasttx，
        ei_local->txing);
  } else { /* We should never get here. */
   if (ei_debug)
    printk("%s: No Tx buffers free. irq=%d tx1=%d tx2=%d last=%d "，
     dev->name， dev->interrupt， ei_local->tx1，
     ei_local->tx2， ei_local->lasttx);
   ei_local->irqlock = 0;
   dev->tbusy = 1;
   outb_p(ENISR_ALL， e8390_base + EN0_IMR);
   return 1;
  }
  ei_block_output(dev， length， skb->data， output_page);
  if (! ei_local->txing) {
   ei_local->txing = 1;
   NS8390_trigger_send(dev， send_length， output_page);
   dev->trans_start = jiffies;
   if (output_page == ei_local->tx_start_page)
    ei_local->tx1 = -1， ei_local->lasttx = -1;
   else
    ei_local->tx2 = -1， ei_local->lasttx = -2;
  } else
   ei_local->txqueue++;

  dev->tbusy = (ei_local->tx1  &&  ei_local->tx2);
    } else {  /* No pingpong， just a single Tx buffer. */
  ei_block_output(dev， length， skb->data， ei_local->tx_start_page);
  ei_local->txing = 1;
  NS8390_trigger_send(dev， send_length， ei_local->tx_start_page);
  dev->trans_start = jiffies;
  dev->tbusy = 1;
    }
  
    /* Turn 8390 interrupts back on. */
    ei_local->irqlock = 0;
    outb_p(ENISR_ALL， e8390_base + EN0_IMR);

    dev_kfree_skb (skb， FREE_WRITE);
  
    return 0;